ASTM A193 Grade B7 Specification for high tensile bolts, screws, stud bolts, threaded rods, anchor bolts and other externally threaded fasteners, made from chromium-molybdenum alloy steel.

ASTM A193 Grade B7 is a standard material specification for chromium-molybdenum alloy steel fasteners for use in high tensile, high temperature and special purpose applications. Grade B7 is a heat-treated chromium-molybdenum alloy steel with minimum tensile requirement of 100 ksi, yield of 75 ksi and maximum hardness of 35 HRC. ASTM A193 specification covers requirements for chemical composition, mechanical properties, hardness, heat-treatment, recommended nuts-washers for Grade B7 fasteners. ASTM A193 Grade B7 is the most widely fastener specifications, commonly found in bolting or piping, pressure vessels, valves, flanges and fittings.

Products

  • ASTM Bolts
    Hex Bolts
  • ASTM Screws
    Heavy Hex Bolts
  • ASTM Studs
    Studs Bolts
  • ASTM Threaded Rods
    Threaded Rods
  • ASTM Anchor Bolts
    Anchor Bolts
  • ASTM Nuts
    Eye Bolts
  • ASTM Washers
    Socket Head Cap Screws
  • ASTM Pins
    Countersunk Bolts
  • ASTM Springs
    U Bolts
  • ASTM Custom-Fasteners
    Square Head Bolts

Chemical Composition

Element Alloy Steel
Chromium Molybdenum SteelA
CompositionB, %
Carbon 0.37 - 0.49C
Manganese 0.65 - 1.10
Phosphorus 0.035 max
Sulfur 0.040 max
Silicon 0.15 - 0.35
Chromium 0.75 - 1.20
Molybdenum 0.15 - 0.25

A: Typical steel compositions used for this grade include 4140, 4142, 4145, 4140H, 4142H, and 4145H.
B: The intentional addition of Bi, Se, Te, and Pb is not permitted.
C: For bar sizes over 31⁄2 in. [90 mm], inclusive, the carbon content may be 0.50 %, max.

Mechanical Properties

Diameter, inch. Tensile Strength,
min, ksi
Yield Strength,
min, 0.2% offset,
ksi
Elongation
in 4D,
min, %
Reduction
of Area,
min, %
Hardness,
max
2-1⁄2 and under 125 105 16 50 321 HBW or 35 HRC
over 2-1⁄2 to 4, inclusive 115 95 16 50 321 HBW or 35 HRC
over 4 to 7, inclusive 100 75 18 50 321 HBW or 35 HRC

Heat Treatment: Quenched & Tempered at 1100º F minimum.

Recommended Nuts & Washers

Nut Specification Washer Specification
ASTM A194 Grade 2H OR ASTM A194 Grade 2HM ASTM F436